нужна инфа по ремонту этой бандуры. Значения индикации на панели управления. Неисправность состоит в том, что после прохождения листа копир выдает ошибку (мигание значков красным на паннели состояния) и потом не работает, т.е его нужно выключить и включить заново.
копир Со startcopy.ru Canon NP7161 Код ошибки Описание E000 The thermistor (TH1, TH2) has poor contact or an open circuit The fixing heater (H1) has an open circuit The thermal switch (TSW1) has turned on The triac is faulty The DC controller PCB is faulty E001 The thermistor (TH1, TH2) has a short circuit The triac is faulty The DC controller PCB is faulty E002 E003 The thermistor (TH1, TH2) has poor contact or an open circuit The fixing heater (H1) has an open circuit The thermal switch (TSW1) has turned on The triac is faulty The DC controller PCB is faulty E004 The triac has a short circuit The DC controller PCB is faulty E010 The main motor (M1) is faulty The DC controller PCB is faulty E013 The waste toner feedscrew is locked The waste toner feedscrew lock sensor (PS8) is faulty The DC controller PCB is faulty E030 The total copy counter has an open circuit The DC controller PCB is faulty E031 The accessories counter has an open circuit The DC controller PCB is faulty (E202) No code indication. Keys are disabled The scanner home position sensor (PS1) is faulty The scanner motor (M2) is faulty The DC controller PCB is faulty E208 The mirror home position sensor (PS3) is faulty The mirror motor (M4) is faulty The DC controller PCB is faulty E210 The lens home position sensor (PS2) is faulty The lens motor (M3) is faulty The DC controller PCB is faulty E220 The lamp regulator PCB is faulty The DC controller PCB is faulty E261 The power supply frequency is faulty The power supply PCB is faulty E710 E711 The DC controller PCB is faulty E712 The DC controller PCB is faulty The ADF controller PCB is fault The ADF cable is faulty E717 The DC controller PCB is faulty The Remote Diagnostic Device II PCB is faulty E800 The auto power-off circuit has an open circuit The DC controller PCB is faulty E805 The exhaust fan (FM2, FM4) is faulty The DC controller PCB is faulty E821 The ozone filter is clogged The cleaner thermistor (TH3) has poor contact or an open circuit The DC controller PCB is faulty Если Вы не смогли найти своей модели в этом разделе, то есть вероятность, что Ваш аппарат является аналогом одного из представленных здесь. Проверить это можно в разделе "Совместимость".